Creating a RAID 1 with the Onboard Intel C612 chipset

Creating a RAID 1 with the Onboard Intel C612 chipset

This guide is to help with the creation of a RAID 1 using the integrated Intel C612 controller.

 

1. Enter the BIOS by hitting the "delete" key. Once there, tab over to the Advanced tab and select the SATA Configuration option and hit 'Enter'.

 

2. The default setting is set to AHCI, change this to RAID.

 

3. You may need to change the default boot select option from sSATA controller to the SATA controller. Depending on where your drives are installed. In this case, it is the SATA controller.

 

4. Hit F4 to save and exit the BIOS.

 

5.  You should now see a new option during POST with the option to hit Ctrl+I to go to the Intel Rapid Storage BIOS, and you should see your two drives listed there as well.

 

6. The default screen will look similar to the following image.  Hit enter to create a new RAID volume.

 

6. Use the enter key to move down from section to section.  Name your volume first, then when you need to select between RAID 0 and RAID 1, use your "Arrow" keys to change RAID modes.  Hit enter when done.

 

7. Once you have made all the changes you want.  Create the Volume. A prompt will come up asking if your really want to continue, hit Yes.  There should be no data on these drives yet so it is safe to create the mirror.

 

8. Here you see the main screen again with your newly created RAID 1.  

 

9. You can now hit 'ESC' to exit this screen and continue loading your OS on your new mirror.

    • Related Articles

    • Configuring Over-Provisioning for Intel SSDs

      The Over-Provisioning setting of an SSD can be modified by a user. It must be performed on an SSD that is in a completely clean state. This can be an SSD that is fresh out of the box that has never been used or by secure erasing the SSD. You can use ...
    • BIOS Setting for Bootable RAID configurations

      When using RAID as an OS Volume, it's important to ensure that all volumes are used for Boot. Certain RAID configurations will require that any drive within the RAID be available as a Boot volume. While UNIX and Windows installers may correctly setup ...
    • Creating FreeDOS bootable ISO

      Prerequisites: Linux mkisofs or genisoimage unzip utility for Linux unix2dos (part of dos2unix packages) This guide will cover creating DOS bootable ISO files to assist with simple and automated firmware updates for the most frequently updated ...
    • Creating a RAID 0, 1, 5 or 6 through the LSI Web BIOS

      This guide is to help with the creation of a hardware RAID using a LSI 9271-4i Controller.  The LSI Web BIOS is similar on most brands of 6Gb/s LSI Hardware controllers. HBA's are not covered in this guide. 1. During POST when the LSI MegaRAID info ...
    • Clearing RAID metadata

      Usage: Disks that were previously in use by a RAID controller will often contain metadata that identifies them as being part of a RAID. The default behavior for the CentOS/RHEL Anaconda installer is to flag and ignore these types of disks in case ...