SMTP "phone home" Mailer Settings

SMTP "phone home" Mailer Settings

Note: If you have a HA Cluster (StorCore 104), you only need to perform this process on one head-node, as it will mirror the email configuration to the second head-node; however, you should double check this.

 

 

  • Navigate to the Nexenta Management Viewer (NMV) on a web browser

 

    • This is the IP address of your management interface. The default port is 2000 (or 8457 on 4.0.X).

 

  • Navigate to the Mailer settings

 

    • Settings > Appliance
      • On the left navigation bar, under the "Administration" module, click "Mailer"
        • You will likely be prompt to log-in here

 

  • Set the Mailer E-Mail Addresses
    • Add the following:
      • E-Mail Addresses
        • zstax-reports@zstax-gateway.siliconmechanics.com
      • E-Mail Addresses for faults
        • zstax-faults@zstax-gateway.siliconmechanics.com
      • E-Mail Addresses for statistics
        • zstax-data@zstax-gateway.siliconmechanics.com
    • Click "Save"
    • Click “Test” to send a test email to verify functionality

    • Related Articles

    • Firewall and port settings

      Q: I can’t seem to get a connection to IPMI, regardless of the IP address settings being used. Do I need to open certain ports on my firewall? A: IPMI needs additional ports opened to access various services. The ports will vary depending on your ...

    • Create an Ubuntu LiveUSB with Persistence

      PREREQUISITES: A USB thumbdrive of 8GB capacity or larger A Windows Workstation with internet access GETTING STARTED: Prepare a USB drive of capacity 8GB or larger. Format the drive in Windows to FAT-32. (Windows will prompt you automatically to do ...

    • Creating a RAID 0, 1, 5 or 6 through the LSI Web BIOS

      This guide is to help with the creation of a hardware RAID using a LSI 9271-4i Controller.  The LSI Web BIOS is similar on most brands of 6Gb/s LSI Hardware controllers. HBA's are not covered in this guide. 1. During POST when the LSI MegaRAID info ...

    • Checking IP address configuration

      Q: How can I check the IP address that IPMI is using? A: The motherboard will list the IP address in the BIOS, usually under IPMI > Set LAN Configuration. By default we leave DHCP turned off and set 0.0.0.0 as the static IP before shipping, for ...

    • Resetting the BMC

      Q: My system's IPMI interface is unresponsive. Can I reboot or refresh the interface? A: If you have local access or SSH access to the system, you can run commands with ipmitool and IPMICFG to attempt to regain accessibility to IPMI. Resets the ...