Replace Failed Drive using MegaCLi

Replace Failed Drive using MegaCLi

Set the drive offline, if it is not already offline due to an error

MegaCli -PDOffline -PhysDrv [E:S] -aN

Mark the drive as missing

MegaCli -PDMarkMissing -PhysDrv [E:S] -aN

Prepare drive for removal

MegaCli -PDPrpRmv -PhysDrv [E:S] -aN

Change/replace the drive

If you’re using hot spares then the replaced drive should become your new hot spare drive:

MegaCli -PDHSP -Set -PhysDrv [E:S] -aN

In case you’re not working with hot spares, you must re-add the new drive to your RAID virtual drive and start the rebuilding process

MegaCli -PdReplaceMissing -PhysDrv [E:S] -ArrayN -rowN -aN
MegaCli -PDRbld -Start -PhysDrv [E:S] -aN

    • Related Articles

    • How to replace a failed HDD using sas2ircu

      1. Run as root: # zpool offline data2 <BAD WWN> 2. Remove the failed disk, then insert the replacement. Wait at least 20 seconds for the drive to initialize. 3. Run as root: # devfsadm -Cv This rescans and removes old dangling device links from the ...

    • MegaCli Common Commands

      General Parameters   Adapter parameter -aN   The parameter -aN (where N is a number starting with zero or the string ALL) specifies the adapter ID. If you have only one controller it’s safe to use ALL instead of a specific ID, but you’re encouraged ...

    • Drive failure behavior

      Q: What is the default behavior when a drive fails? A: The default settings for a MegaRAID controller will enforce an automatic rebuild policy, and usually an automatic copyback as well. The automatic rebuild, in the presence of commissioned hot ...

    • Clearing RAID metadata

      Usage: Disks that were previously in use by a RAID controller will often contain metadata that identifies them as being part of a RAID. The default behavior for the CentOS/RHEL Anaconda installer is to flag and ignore these types of disks in case ...

    • Locating failed drives

      Q: I need to remove a failed drive from my array, but I’m not sure which slot it resides in. How can I physically identify the failed disk? A: The faulted drive should be automatically marked with the red fault light. If this did not occur ...